Categories

Company: Shandong Zhongjing Solar Energy Co.,Ltd

Factory address:No.6 Taikang Road, Economic & Development Zone of Weishan County, Jining City, Shandong Province, China

Contact person:Jeffery Yan

Mobile:0086 15206715713

Tel: 0086 537 5031068

Fax: 0086 537 5031002

Email: international@cnsdpv.com

Skype: jefferypv1029

WhatsApp: 008615206715713

WeChat: 008615206715713

Website: http://www.cnsdpv.com

Home > News > Content

Introduction And Characteristics Of Solar Systems

    (1), solar panel (2), U-shaped groove frame (3), pulley block (4), box slide (5), the body of the slide bracket (8), an isolation protection pad (9), a housing outer rail (10), a housing outer rail bracket (11) and a three-phase link (2), a U-shaped groove frame (3), a pulley block (4), a housing slide rail (5), a housing inner rail bracket (6), an isolation  Solar Systems protection pad (2) (11) and a three-phase link (12) are arranged in the casing (1), the casing wheel support (7) and the tank wheel (10), the outer rail (8) is arranged on the outer bottom surface of the bottom plate (11) of the box body (1), and has a compact box structure, compact structure, large power supply capacity, quick installation and quick evacuation.

    1, the use of a single chip and special software to achieve the intelligent control; 2, the use of battery discharge rate characteristics of the correct discharge control. The discharge termination voltage is a control point corrected by the discharge rate curve, eliminating the inaccuracies of the simple voltage control overdraft, in accordance with the inherent characteristics of the battery, i.e. the different discharge rates have different termination voltages. 3, with overcharge, over discharge, electronic short circuit, overload protection, unique anti-reverse protection and other automatic control; the above protection does not damage any parts,Solar Systems  do not burn insurance; Solar Systems

    4, using a series PWM charge the main circuit, The charging circuit voltage loss than the use of diode charging circuit reduced by nearly half, the charging efficiency than non-PWM 3% -6% higher, increasing the power time; over discharge recovery to enhance the charge, the normal direct charge, float automatic control 5, intuitive LED light tube indicates the current battery status, allowing users to understand the use of the situation; 6, all control all use of industrial-grade chip (only with the I industrial level (5), the use of high-precision temperature compensation system; Controller), in the cold, high temperature, humid environment to run freely. At the same time the use of crystal timing control, timing control accuracy. 7, cancel the potentiometer to adjust the control set point, and the use of E-side memory records the work of the control point, so that the set of digital, eliminating the potentiometer vibration bias, temperature drift, so that the control point error reduction accuracy and reliability 8, the use of digital LED display and settings, one-button operation to complete all settings, the use of extremely convenient and intuitive role is to control the work of the entire system, and the battery played a charge protection, over discharge protection The role. In the larger temperature difference, the qualified controller should also have the function of temperature compensation. Other additional functions such as light control switch, time control switch should be the option of the controller;Solar Systems